mass spectrometry raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-02-05 and is reviewed periodically as new material appears.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Selank is a synthetic heptapeptide developed in Russia. Its sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, a seven-residue chain built around the natural tetrapeptide tuftsin. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences first described the compound in the mid-1990s. The design combined the tuftsin core with an added Pro-Gly-Pro tail, a modification intended to extend the molecule's stability in biological fluids. Published work on the peptide has appeared mainly in Russian-language journals.
Reported activity for Selank centers on anxiolytic and nootropic effects. Russian clinical reports describe use in anxiety and in cognitive or attention-related complaints. Most of this evidence comes from studies conducted by the same research groups that developed the peptide. Independent replication in other countries remains limited, and no major Western regulatory agency has approved the compound for any indication. The gap between local reports and external verification is a recurring point in discussions of the peptide.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
== Use and effects == In his book PiHKAL (Phenethylamines I Have Known and Loved) and other publications, Alexander Shulgin lists 2C-B's dose range as 12 to 24 mg orally and its duration as 4 to 8 hours. However, in an earlier report, he described an effective dose range of 8 to 10 mg orally and a duration of 6 to 8 hours. Threshold effects occur at a dose of 4 mg orally. A wider recreational dose range of 2 to 55 mg or more orally has been described as well, with a typical dose estimate of about 20 mg. A low dose has been said to be 5 to 15 mg, a moderate dose 10 to 25 mg, and a high or strong dose 20 to 50 mg. Most people use doses of 20 mg or lower. Shulgin and others describe 2C-B as having a steep dose–response curve, such that a small increase in dose can result in an unexpectedly large increase in effects. Over the 12 to 24 mg dose range, every 2 mg increment can result in a profound increase or change in effects. Higher doses are said to lead to more intense but not longer-lasting effects. The drug's onset is about 0.5 to 1.2 hours, with a range of 0.3 to 1.5 hours, and its time to peak effects is about 2.5 hours on average. Effects last about 3.1 to 4.9 hours on average and are shorter than those of psilocybin. In addition to oral administration, 2C-B may be insufflated less commonly, with doses being approximately one-third of those of the oral route or in the range of 10 to 30 mg and with this route producing more rapid and intense effects.
Strategies for preventing link rot can focus on placing content where its likelihood of persisting is higher, authoring links that are less likely to be broken, taking steps to preserve existing links, or repairing links whose targets have been relocated or removed.
=== Gonads and sexual development === In mice, adropin treatment significantly increased sperm count and testicular testosterone by increasing expression of GPR19 and steroidogenic proteins via modulating redox potential. In the mouse ovary, adropin and GPR19 are strongly detected in the granulosa cells of large antral follicles and corpus luteum. An additional study suggests a role for adropin in the acceleration of pubertal development.
Sources: en.wikipedia.org
Transforming growth factor beta (TGF-β) is a multifunctional cytokine belonging to the transforming growth factor superfamily that includes three different mammalian isoforms (TGF-β 1 to 3, HGNC symbols TGFB1, TGFB2, TGFB3) and many other signaling proteins. TGFB proteins are produced by all white blood cell lineages. Activated TGF-β complexes with cell surface TGF-β receptors to form an active serine/threonine kinase complex. After binding their TGF-β protein ligand, TGF-β receptors assemble into heterotetramers composed of two each of the type 1 and type 2 receptor subunits, both of which are serine/threonine kinases. Upon assembly, the type 2 receptor kinase phosphorylates and activates the type 1 receptor kinase to initiate a signaling cascade. This leads to the activation of different downstream substrates and regulatory proteins, inducing transcription of different target genes that function in differentiation, chemotaxis, proliferation, and activation of many immune cells. TGF-β is secreted by many cell types, including macrophages, in a latent form in which it is complexed with two other polypeptides, latent TGF-beta binding protein (LTBP) and latency-associated peptide (LAP). Serum proteinases such as plasmin catalyze the release of active TGF-β from the complex. This often occurs on the surface of macrophages where the latent TGF-β complex is bound to CD36 via its ligand, thrombospondin-1 (TSP-1). Inflammatory stimuli that activate macrophages enhance the release of active TGF-β by promoting the activation of plasmin.
This is a shortened version of the thirteenth chapter of the ICD-9: Diseases of the Musculoskeletal System and Connective Tissue. It covers ICD codes 710 to 739. The full chapter can be found on pages 395 to 415 of Volume 1, which contains all (sub)categories of the ICD-9. Volume 2 is an alphabetical index of Volume 1. Both volumes can be downloaded for free from the website of the World Health Organization.
Obesity can lead to social stigmatization and disadvantages in employment. When compared to their ideal-weight counterparts, workers with obesity, on average, have higher rates of absenteeism from work and take more disability leave, thus increasing costs for employers and decreasing productivity. A study examining Duke University employees found that people with a BMI over 40 kg/m2 filed twice as many workers' compensation claims as those with a BMI of 18.5 to 24.9 kg/m2. They also had more than 12 times as many lost work-days. The most common injuries in this group were due to falls and lifting, thus affecting the lower extremities, wrists or hands, and backs. The Alabama State Employees' Insurance Board approved a controversial plan to charge obese workers and those with other health conditions $50 a month for health insurance that would otherwise be $25 unless they take steps to lose weight and improve their health. These measures started in January 2010 and apply to those state workers whose BMI exceeds 35 kg/m2 or who have other health conditions and who fail to take steps to make improvements in their health after one year. This becomes a Catch-22 situation, as many insurance companies refuse to pay for treatment methods for workers living with obesity. Some research shows that people with obesity are less likely to be hired for a job and are less likely to be promoted. People with obesity are also paid less than their counterparts (who do not live with obesity) for an equivalent job; women with obesity on average make 6% less and men with obesity make 3% less.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.