This is a working overview of heptapeptide, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-08-15 and is reviewed periodically as new material appears.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Published work on this peptide almost always uses intranasal delivery, with drops or a spray applied to the nasal mucosa. Some animal experiments have used subcutaneous or intraperitoneal injection, and a smaller number have compared routes directly. Oral administration is not a focus of the literature, because short peptides of this size are broken down by digestive enzymes and cross intestinal barriers poorly. How much of an intranasal dose reaches the bloodstream intact in humans remains an open question.
Animal studies have examined behaviour in tests of anxiety, memory retention and stress response, and several report changes in neurotrophic or neurotransmitter-related markers. The human evidence base is much smaller, consisting mainly of short trials conducted in Russia with limited reporting in English-language journals. Sample sizes are modest and outcome measures vary between studies, so the findings are best described as preliminary. Independent replication under modern trial standards has not been widely reported.
Outside its country of origin the compound is generally handled as a research chemical rather than an approved medicine. No regulatory approval from the United States Food and Drug Administration or the European Medicines Agency has been granted for human use. Identity and purity are normally checked by reverse-phase high-performance liquid chromatography, with mass spectrometry used to confirm the molecular mass. Lyophilised material is stored cold and desiccated, and repeated freeze-thaw cycles are avoided.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by RP-HPLC | Area percentage of the main peak |
| Identity confirmation | Electrospray ionization mass spectrometry | Observed mass compared with the theoretical value near 751.9 Da |
| Recommended dry storage | -20 °C, desiccated | -80 °C for multi-year archival material |
| Solution handling | Prepare fresh; avoid long storage | Sterile filtration reduces microbial load |
| Common synonyms | TKPRPGP; TP-7 | Sequence code and laboratory designation used interchangeably |
The primary structure of Selank is Thr-Lys-Pro-Arg-Pro-Gly-Pro, corresponding to the molecular formula C33H57N11O9 and a monoisotopic mass of roughly 751.9 daltons. The N-terminal threonine and the arginine residue in the fourth position are shared with tuftsin, which carries the sequence Thr-Lys-Pro-Arg. The three additional residues at the C-terminus, Pro-Gly-Pro, extend the chain and are associated with greater resistance to enzymatic degradation. This extension also separates Selank from the shorter parent peptide.
Naming conventions place Selank in the same research family as Semax, another Russian-developed peptide investigated for cognitive effects. The two compounds share a lineage but differ in sequence and in the biological systems proposed as their targets. Semax descends from ACTH fragments, whereas Selank descends from tuftsin. Publications sometimes identify Selank by its full peptide sequence or by laboratory codes rather than one uniform trade name. Because replication outside Russia is limited, reports on its properties are best read alongside the study design and the purity of the material tested.
Selank is a synthetic heptapeptide developed in Russia during the 1990s. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences designed it as a stabilized analog of tuftsin, a naturally occurring immunomodulatory tetrapeptide. The compound has been studied primarily for its reported anxiolytic and nootropic effects. It remains largely unknown in Western pharmacology and is not approved as a medicine by major regulators such as the FDA or the EMA.
Tuftsin, the parent structure, is a naturally occurring immunomodulatory tetrapeptide released from the Fc region of immunoglobulin G by spleen enzymes. Selank extends this four-residue sequence with three additional amino acids. The stated rationale is that the added tail slows enzymatic breakdown and may influence receptor interactions. How the full heptapeptide behaves at the molecular level is not firmly established, and proposed mechanisms often involve indirect modulation of neurotransmitter or immune signaling rather than a single defined target.
Selank is a synthetic heptapeptide developed in Russia. Its sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, a seven-residue chain built around the natural tetrapeptide tuftsin. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences first described the compound in the mid-1990s. The design combined the tuftsin core with an added Pro-Gly-Pro tail, a modification intended to extend the molecule's stability in biological fluids. Published work on the peptide has appeared mainly in Russian-language journals.
Reported activity for Selank centers on anxiolytic and nootropic effects. Russian clinical reports describe use in anxiety and in cognitive or attention-related complaints. Most of this evidence comes from studies conducted by the same research groups that developed the peptide. Independent replication in other countries remains limited, and no major Western regulatory agency has approved the compound for any indication. The gap between local reports and external verification is a recurring point in discussions of the peptide.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
Acceptance sampling procedures became common during World War II. Sampling plans, such as MIL-STD-105, were developed by Harold F. Dodge and others and became frequently used as standards. More recently, quality assurance broadened the scope beyond final inspection to include all aspects of manufacturing. Broader quality management systems include methodologies such as statistical process control, HACCP, six sigma, and ISO 9000. Some use of acceptance sampling still remains.
Aldo-keto reductase family 1 (AKR1) is a family of aldo-keto reductase enzymes that is involved in steroid metabolism. It includes the AKR1C and AKR1D subgroups, which respectively consist of AKR1C1–AKR1C4 and AKR1D1. Together with short-chain dehydrogenase/reductases (SDRs), these enzymes catalyze oxidoreductions, act on the C3, C5, C11, C17 and C20 positions of steroids, and function as 3α-HSDTooltip 3α-Hydroxysteroid dehydrogenases, 3β-HSDsTooltip 3β-Hydroxysteroid dehydrogenases, 5β-reductases, 11β-HSDsTooltip 11β-Hydroxysteroid dehydrogenases, 17β-HSDsTooltip 17β-hydroxysteroid dehydrogenases, and 20α-HSDsTooltip 20α-Hydroxysteroid dehydrogenases, respectively. The AKR1C enzymes act as 3-, 17- and 20-ketosteroid reductases, while AKR1D1 acts as the sole 5β-reductase in humans. AKR1A1; AKR1B1; AKR1B10; AKR1C1; AKR1C2; AKR1C3; AKR1C4; AKR1D1; Others Steroidogenic enzyme
== Boron-8 == Boron-8 is an isotope of boron that undergoes β+ decay to beryllium-8 with a half-life of 771.9(9) ms. It is the strongest candidate for a halo nucleus with a loosely-bound proton, in contrast to neutron halo nuclei such as lithium-11. Although boron-8 beta decay neutrinos from the Sun make up only about 80 ppm of the total solar neutrino flux, they have a higher energy centered around 10 MeV, and are an important background to dark matter direct detection experiments. They are the first component of the neutrino floor that dark matter direct detection experiments are expected to eventually encounter.
Sources: en.wikipedia.org
In multiple electrode aggregometry, anticoagulated whole blood is mixed with saline and a platelet agonist in a single-use cuvette with two pairs of electrodes. The increase in impedance between the electrodes as platelets aggregate onto them, is measured and visualized as a curve.
The stand-off cost three demonstrators their lives in clashes with the army on the night of 20–21 August before the coup leaders, lacking the broad military backing they needed and rapidly losing the fear that had sustained their authority, lost their nerve; Estonia and Latvia seized the moment to declare independence, and coup leader Boris Pugo took his own life rather than face arrest. Gorbachev formally resumed his powers on returning to Moscow, but by then the substance of power had already passed elsewhere—the Communist Party did not even condemn its own plotters until 21 August, by which point Yeltsin had exploited its paralysis to ban the Party outright within the Russian federation. Yeltsin's courage in personally defending the parliament building may have helped break the putsch but at the cost of Gorbachev's remaining authority.
=== Juice content === The juice content of the plant varies depending on the age of the plant, since younger plants contain more juice than older ones. The plant provides the least juice after seed maturation because the leaves have already begun decay at that point. Depending on the kind of press used, the amount of resulting juice varies significantly. On average, 50% of the weight of the plant is obtained as juice. The water to dry matter ratio of the juice shows high dry matter content in the upper part of the plant, and is lowest in the leaves when the seeds are ripe. The dry matter content is medium in the fibers and lowest in the shives. The relatively high content of dry matter implies a high percentage of substance components such as carbohydrates, amino acids, protein, fat, cannabinoids, polyphenols, as well as other substrates.
Fasting plasma glucose level ≥ 7.0 mmol/L (126 mg/dL). For this test, blood is taken after a period of fasting, i.e. in the morning before breakfast, after the patient had sufficient time to fast overnight or at least 8 hours before the test. Plasma glucose ≥ 11.1 mmol/L (200 mg/dL) two hours after a 75 gram oral glucose load as in a glucose tolerance test (OGTT) Symptoms of high blood sugar and plasma glucose ≥ 11.1 mmol/L (200 mg/dL) either while fasting or not fasting Glycated hemoglobin (HbA1C) ≥ 48 mmol/mol (≥ 6.5 DCCT %).
Sources: en.wikipedia.org
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.
A reported purity value reflects the share of the main peak in one chromatographic run and says nothing about identity. Confirming that the expected sequence is present requires a separate measurement such as mass spectrometry. Purity and identity are distinct questions.
A mass spectrum reports the molecular masses present in a sample and shows whether they match the value expected for selank, near 751.9 Da. It also flags common artifacts such as truncation or adduct formation. It does not establish correct stereochemistry or complete sequence order on its own.
Most published work uses intranasal application, either as drops or as a nasal spray. Injection routes appear in a smaller set of animal experiments. Oral use is uncommon in the literature because peptide breakdown and poor absorption limit this route.